We are using 3 MetaMotionR sensors. We
are trying to use the GPIO ports using MetaWare APP (android), to be sure that
it is not a problem of our APP developed.
0 is used as an input (form analog circuit to the sensor), reading an analog
signal from 0 to 2.5V.
1 is used by Output, putting an UP (3v) to control the system.
is work properly for 5-8 minute, but suddenly it stop to capture in port 0 and it doesnt work again. I
thought that was some error with my electronic circuit, so I use “pull Mode”
and I see that after some minute the sensor is stoped the load the port. I have
check the accelerometer in order to be sure that was not a error of the
microprocessor, and it is working.
I want to use the sensor to load again or use the port, I have to reset the sensor.
have the same issue with all the sensor.
could you help me with this issue?
Thanks in advance,