siroboris

Comments

• Since updating my boards to firmware 1.2.4 I am still experiencing this same issue. @Magda: can you confirm that updating the firmware resolved the issue for you? If so my problem must lie somewhere else... Cheers!

  in Board stops sending data after few sequential connect-disconnect cycles (possibly a firmware bug) Comment by siroboris October 2016
• Hi, I am experiencing essentially the exact same issue as mgdbgj and asad. I am also using the High Frequency Stream of the Accelerometer and Gyro. I just need to let the stream run and it will break down after anywhere between 30s and 2 minutes. …

  in Board stops sending data after few sequential connect-disconnect cycles (possibly a firmware bug) Comment by siroboris September 2016
• Yes the problem was that I had offline mode enabled! Thanks for you fast and helpful response Cheers, Phil

  in Android API v2.6.0 Comment by siroboris August 2016
• Hi Eric, I want to upgrade to the API v2.6.0 from 2.5.9 to use the high frequency streams. A pretty straight forward task you would think however when updating my gradle file I get the error message: "Failed to resolve: com.mbientlab:metawear:2.6.…

  in Android API v2.6.0 Comment by siroboris August 2016