irmw
About
- Username
- irmw
- Joined
- Visits
- 32
- Last Active
- Roles
- Member
Comments
-
@Laura Ok I tried powering it with power supply and higher V battery but it still gave me the same problem, It didn't read the i2c at all and the device went to MetaBoot mode right after. One thing on my mind is it possible that one of the i2c add…
-
@Laura It definitely worked with 6 of the sensors before, might bigger battery (more mAh) solve the problem? or I need separate regulator with higher V battery? It still didnt work with USB connected
-
@Laura Should I power it with other means?
-
@Laura it's the +3V pin on the Metawear
-
@Laura Yes I tried with 1,2,4, and 6 of the sensors and they all worked, it's just that it didn't even run the code. However, it worked with arduino. The connections are all already fixed so I can't redo them. I connected it like a typical master…
-
@Eric said: 1. Post the code you are running 2. Post device information * Grab from MetaBase app if unsure * hardware revision, firmware, model number 3. What I2C devices are you using and how are they connected to the board?
-
Btw whats the value of i2c pull-up resistors on the MetaWear?
-
Hi Eric, Hope you can help me! I also tried using different MetaWear and the result is the same, sometimes I got this too Traceback (most recent call last): File "data_stream_fin.py", line 238, in s = State(d) File "data_stream_fin.py"…