AllanLab
About
- Username
- AllanLab
- Joined
- Visits
- 0
- Last Active
- Roles
- Member
Comments
-
So you can only call the haptics once? Once per ... connection, reset, ever? Your comment doesn't make sense to me because we are able to call the haptics over and over again, it's just that it will eventually, randomly fail with that error, and we'…
-
What is the intended way of using your sensor? All we are doing is connecting to the board using the python library you provide - most, if not all of the code is from examples your company provide . So, i'd be grateful if you could try. Ill repea…
-
Further, unfortunately the metawear SDK doesn't even raise an appropriate exception here, which means we cannot error handle gracefully!
-
That's just an example of me interacting with the board from a python shell. In this case i'm repeatedly calling the haptic motor, until it fails, which in this case is on the second call.
-
Hrmm, maybe i'm not being clear enough: the following code connects to the board and vibrates, as the logs show, it then immediately fails. This is a common experience, and we get to, perhaps, a maximum of 5 sequential haptic vibrations before we…
-
OK, we can live with careful error handling. Any ideas on the second point? I.e. "Failed to write value to characteristic(Error trying to issue command mid state)," after a haptic command. In this case, i seem to be connected to the board but una…
-
Laura, i haven't the time to test it right now. I guess the tooling to compile on ARM devices isn't quite setup right. I haven't much experience in this area. I have now moved over to the official raspbian release, which is working. For those try…
-
full log: https://pastebin.com/e59HRP7y
-
@Laura said: Most people need capitals. Hmmm.
-
Thanks, No need for the CAPITALS, however. I'm perfectly capable of reading lowercase.