MichaelH

About

Username
MichaelH
Joined
Visits
37
Last Active
Roles
Member

Comments

  • TL;DR The answer is: x_value = parse_value(data).x, etc.
  • @Laura said: Check out the reset section. That section starts with an 'if', the documentation does not say 'run this every time to ensure a clean shutdown'. In any case, why would the board be "stuck in a bad state or need to be reset" af…
  • @Laura said: 1) No, please see our tutorial on proper resets/disconnects to ensure no issues with the BLE link. The tutorial basically shows device = MetaWear(address) device.disconnect() so there's not much one can do wrong. If yo…