TalStein

About

Username
TalStein
Joined
Visits
9
Last Active
Roles
Member

Comments

  • Posting the solution if anyone ever needs it. P0.09 and P0.10 (Haptic Pin) are reserved for NFC use by default, and that prevents their use as regular GPIOs. adding the definition "CONFIG_NFCT_PINS_AS_GPIOS" in the preprocessor solves this issue.
  • @Laura said: Unfortunately we don't support custom firmware. I understand, Thank you for the response. Is there some way of receiving payed support for custom firmware?
  • @mgeorgi have you had any luck solving this issue? I seem to be experiencing the same thing. I am unable to turn the motor ON via set/clear commands to the pin, even with high drive strength. The motor will turn ON if I set the pin to be pulled up,…