KingTalullah

Comments

• Ah, I had a feeling I was missing something.  Thanks for the instructions.  I will take care of it.

  in HCD Pin not working on hw version 0.3 on C module Comment by KingTalullah June 2016
• I'm using the mbientlab app.

  in HCD Pin not working on hw version 0.3 on C module Comment by KingTalullah June 2016
• I've tried connecting both the piezo speaker and the coin battery to the 0.3, both of which work on the 0.2.  I've also tested with a multi-meter and the HCD pin just floats.  On the 0.2, I see 3V across.

  in HCD Pin not working on hw version 0.3 on C module Comment by KingTalullah June 2016
• Ok, that worked for me.  I was able to recover, although the buzzer and/or speaker don't seem to be working on this rev of hardware, but that's a separate issue.

  in "Error: Error on Receive Firmware Image. Message: Invalid Response" Comment by KingTalullah May 2016
• Did you mean the nRF Toolbox app?  The master control panel app did not have a way to perform DFU.

  in "Error: Error on Receive Firmware Image. Message: Invalid Response" Comment by KingTalullah May 2016
• Any update on this?

  in Add ability to configure frequency of HCD Comment by KingTalullah April 2016
• A configurable setting would be awesome!

  in Add ability to configure frequency of HCD Comment by KingTalullah March 2016
• How would you do this in iOS?  If a device goes out of range, I would like the app to attempt to reconnect to it every 1 minute or so.

  in Example code for automatically reconnecting Comment by KingTalullah March 2016