Missing docs

maro · September 2014

Hi,

I'm a backer from the kickstart campain.

I'm a software developer with a very little knowledge about electronic. My problem is that i don't know how to connect the extra sensors to the board.

Are you going to provide a documentation?

Thanks

Ps. I was expecting this stretch goal:

$35,000 - USB cables come in every Kit to re-charge your MetaWear

but i didn't find it in the package

Kcraft · September 2014

Hello Maro,

I'm going to steal Eric's post from http://community.mbientlab.com/discussion/108/how-to-connect-buzzer

"

Buzzer pin details are in the preliminary product spec pdf file under section 8, "Typical Application Circuit"

https://mbientlab.com/docs/MetaWearPPSv0.6.pdf

"

Does that answer your question? The PS will have to be handled by someone who works at mbientlab.

Eric · September 2014

The stretch goals were retracted on the kickstarter page due to lack of man power and budget. However, since we have extra time on our hands as the campaign is done, we are going to add the heart rate sensor and have already uploaded the CAD enclosures.

maro · September 2014

Thanks for the information.

So in my package what I received?

I have the board and the battery whit

a coin vibrator
a buzzer
2 resistor
2 extra sensor

One of the extra sensor is the heart sensor? If not where can i buy one? I'm very interested about make an application whit the heart sensor.

andrew · September 2014

If you got the same kit as me the two sensors are a thermistor (for measuring temperature) and a light-dependent resistor.

Andrew

Laura · September 2014

@maro,

Check out these Pulse Sensor guys, there made a really amazing heart rate sensor and had a really good crowdfunding campaign: http://pulsesensor.myshopify.com/.

I'm planning on doing a hack with the Pulse Sensor as soon as I can and I will publish it on www.projects.mbientlab.com.

Laura · November 2014

http://projects.mbientlab.com/heart-rate-data-with-the-pulse-sensor-and-metawear/

Missing docs

Comments