›

Logging rate for Magnetometer

ErykMATErykMAT
in General
Hello is there a way to increase the logging frequency of the magnetometer?

I am trying to use the magnetometer to detect RPM of a rotating object ( i can't use the gyro or accelerometer due to project constraints).

I would need about 200 300 Hz, looking at the datasheet BMM150 could do up to 300Hz ODR in low power preset and 100 Hz in Regular preset when the measurement is 'forced', can this be configured by a BLE command?

Comments

  • EricEric
    Those higher data rates are only applicable when the sensor operates in "forced" mode, which we do not support.
This discussion has been closed.