›

peak voltage in GPIO signal.

Stud1Stud1
in Requests & Bug Reports
Hi!
I have metawear c and metawear R sensor. I have not connect any device to GPIO pin but when i open the metawear android application and open the GPIO signal it has to show some signal and every 10ms peak of that GPIO signal going to high.

Comments

  • EricEric
    edited September 2017
    • Which gpio signal and pin are you reading from?  
    • What firmware are the boards running?  
    • What values are being recorded?

    I do not see such behavior with a CPro or MotionR board.  The only time the analog data changes is if I touch the pin.
This discussion has been closed.