›

MetaBoot mode after firmware update

IshwinderIshwinder
in Firmware

I just pulled one older MetaMotion device today for some tests and when connected with MetaWear app gave me an option to upgrade to latest Firmware. I hit ok button by mistake and it started updating the firmware. Now the device is in MetaBoot mode and I am not able to connect with MetaWear and Metabase.

Comments

  • IshwinderIshwinder

    with Metabase, was able to connect from Diagnostic tab. Firmware version on device is 0.2.1.
    When trying to update it shows error "operation failed. ensure the firmware targets that device type and version"

  • EricEric
    • What error messages are displayed in Logcat when attempting to update the board with MetaBase?
    • Is the battery fully charged when doing the firmware update?
    • When in the update does the operation fail?
  • yianmaryianmar

    My metawear R just is at MetaBoot mode for days,
    It happened after an firmware update procedure.
    The name is MetaBoot and no application can connect even if it is found.
    Hard reset did not work neither.
    What to do???????????????

  • EricEric

    @yianmar said:
    My metawear R just is at MetaBoot mode for days,
    It happened after an firmware update procedure.
    The name is MetaBoot and no application can connect even if it is found.
    Hard reset did not work neither.
    What to do???????????????

    What is the hardware revision and model of the board?

  • yianmaryianmar

    @Eric said:

    @yianmar said:
    My metawear R just is at MetaBoot mode for days,
    It happened after an firmware update procedure.
    The name is MetaBoot and no application can connect even if it is found.
    Hard reset did not work neither.
    What to do???????????????

    What is the hardware revision and model of the board?

    Metamotion R
    Hardware 0.1
    Serial Number 00EBAB

  • EricEric
    edited June 2018

    Here is a direct link(v1.3.7 at time of post). Find the nRF Connect app for your mobile device and use the app to manually upload the firmware.

  • yianmaryianmar

    Thanks

This discussion has been closed.