›

MetaMotionR+

CarltonGucCarltonGuc
in Hardware

We're almost complete with our development of a product that uses the MotionR+ and currently use the 3+, HDC, ADC1 and ADC0 connector points on the board to connect to an external sensor. Works fine, but solding is a bit difficult and if the sensor goes bad, removing the sensor and replacing is nearly impossible w/o damage to the MotionR+.

Having a 4 pin connector would be ideal where we can just plug the sensor in, when it goes bad, just plug in another sensor.

Any suggestions on a part number? I'm sure something like this must exist.

Thanks
Carlton

Comments

  • LauraLaura

    I don't know if an exact part but you should take a look at Newark and Digikey.

Sign In or Register to comment.