›

iOS Sensor Fusion sample app

physiowearphysiowear
in iOS
When I run the app I get as far as the message "place the device on a level surface for a few seconds" which I have done but nothing happens. Any suggestions please?

Comments

  • EricEric
    • What board are you using?
    • What is the firmware version?
    • What Xcode version are you developing on?
    • What iOS device are you running the app on?
    • What are the exact steps to reproduce?
  • physiowearphysiowear
    CPro
    1.2.4
    8.0
    iPhone 6S

    I downloaded the project from GitHub and opened the SensorFusion.xcworkspace file. Then I ran the project from Xcode. The app recognized my device, I connected to it, then on the 'Device' screen the message appeared. And I can't get past that.

  • LauraLaura
    You should read through the code and update it as needed based on your application. It's free open source code and should be maitained by the community.
  • physiowearphysiowear
    Yes I was hoping for some feedback from the community. Although I am somewhat miffed that no one at mbientlab can't even get me past the first screen. Has anyone out there tried this app? Did it work for you?
This discussion has been closed.