Autonomous chain of onboard sensors

udi_o · February 2016

Hi,

Currently I manage successfully the activation and control of the RPRO sensors from the Android via streams.

However, my project requires the flow of the sensing activities to work without the BLE control at every stage.

So is it possible to chain multiple activities on the configuration command e.g. start ambient light sensor and when its sampled value reach specific threshold trigger GPIO ADC sampling, then when GPIO ADC reach specific value turn LED.

Please advise

Eric · February 2016

Check out the section titled Routing Sensor Data on the Android documentation, specifically the data processor and data monitor.

udi_o · February 2016

Thanks for the prompt reply - I'll give it a go.

Autonomous chain of onboard sensors

Comments