CPro cann't connect.

Comments

• wmeinhold

  December 2016 edited December 2016

  I am having the same issue with a C board. 

  
  

  The metawear app now only sees the board if the app is in metaboot mode, and if I connect, it shows the firmware update progress bar for ~10 seconds then gives an error that says "Device disconnected unexpectedly"

  
  

  
  

  Edit: the 50th time I tried to update the firmware, it worked and the board is now discoverable. 
  

  
  

  I started the metawear ios app in metaboot mode, put a brand new battery into the board, then held the switch down for ~5 seconds and connected. This time it did not time out, and updated successfully. 
• Eric

  December 2016

  @kyle

  What mobile device are you using to scan for the device?  Does the metaboot workarond used by @wmeinhold  fix your issue?
• kyle

  December 2016

  Sorry for my poor description.

  I could connect CPro do something at last week, but now even scan Bluetooth is not found, that is my problem now.

  So how should I do to fix the problem?
  thanks.
• Eric

  December 2016

  As stated in my previous post, does the fix mentioned in wmeinhold's post fix your issue?
• kyle

  December 2016

  No, nothing was shown in MetaWear and MetaBase scan.
  So I can't try that process.

  thanks.
• Eric

  December 2016

  You can force the board into metaboot mode by holding down the button and inserting the battery.
• kyle

  December 2016

  Thanks for the help.

  What signal will show when it get into metaboot mode?
  I had tried:

  1.Holding down the button then inserting the battery.

  2.Inserting the battery first then holding down the button 10 seconds.

  But seems like didn't work.
• Eric

  December 2016

  If you're using the iOS MetaWear app, you will need to switch the app into MetaBoot mode.