›

JST-PH 2-Pin connector..

bhaidayabhaidaya
in General
Has anyone added one of these to a board to allow for easy removal of the battery? it seems that i often have to reset the the device in order to re-connect it again, after say crashing the android example app.

Is there another way to reconnect it? other than unplugging it and replugging it into the usb?

I'm reluctant to solder my battery on until i figure out a good way to do this.

Comments

  • GuarneriGuarneri
    You should be able to reset the device by holding down the switch and plugging it into the usb, even if the battery is soldered on.

    If that doesn't work, there are a few pins you can touch with a paper clip to reset the device as well.
  • bhaidayabhaidaya
    Great i'll try it out! Thanks!
This discussion has been closed.