While working with the hardware , it sometimes stops working and then for long it is not even discoverable. Why does this happen ? Is their any solution to reset the device in such a case ?
Your battery is simply low or perhaps you did something that caused the board to go into MetaBoot. Use the sample MetaWear App and a good DMM to quickly debug this.
You can reset the device by simultaneously holding the push-button down while plugging in the USB charging cable (this will trigger a device reset and send the MetaWear board into MetaBoot mode for 30 seconds).
NOTE: All other power sources must be disconnected!
Hey Laura. Did ALL of the reset methods make it into the getting started guide? I'd imagine that some people would like to know about the "super-secret" reset pin (21?).
Comments