Hardware Behaviour

While working with the hardware , it sometimes stops working and then for long it is not even discoverable. Why does this happen ? Is their any solution to reset the device in such a case ? 


  • edited February 2015
    Your battery is simply low or perhaps you did something that caused the board to go into MetaBoot. Use the sample MetaWear App and a good DMM to quickly debug this.

    You can reset the device by simultaneously holding the push-button down while plugging in the USB charging cable (this will trigger a device reset and send the MetaWear board into MetaBoot mode for 30 seconds).

    NOTE: All other power sources must be disconnected!
  • edited January 2015
    Hey Laura. Did ALL of the reset methods make it into the getting started guide?  I'd imagine that some people would like to know about the "super-secret" reset pin (21?).
This discussion has been closed.