After stopping streaming and closing Metabase, device's red LED remains blinking every 30 seconds or so and after sometime substantially drains battery.
Hello Eric, I received today the MetamotionR, I'e the same problem of Keith, I tried to reset and set again it but it doesn't work in the screen where there is devices list into the right there is the red circle, also about red LED.
It worked only the first time. Do you have some idea? Thank you so much
@denisb said:
Hello Eric, I received today the MetamotionR, I'e the same problem of Keith, I tried to reset and set again it but it doesn't work in the screen where there is devices list into the right there is the red circle, also about red LED.
It worked only the first time. Do you have some idea? Thank you so much
Did you do what I suggested in my previous post?
@Eric said:
Use the selected device's diagnostic screen to reset the board.
@Eric, I already done but I didn't fix the problem.
I tried also soft reset but without results.
Now I've a new problem with MetaBase App. I disconnected by Metabase app the sensor and now if I try to reconnect the app close itself like a crash.
I installed the app in a laptop with windows10.
I don't know how to do
@denisb,
Great, keep us updated.
It seems your metatracker is stuck in log mode but works fine if you can just update or reset it with an iPhone and a fresh MetaBase install.
I had this happen to someone else and the iOS firmware update fixed everything.
Comments
Use the selected device's diagnostic screen to reset the board.
Hello Eric, I received today the MetamotionR, I'e the same problem of Keith, I tried to reset and set again it but it doesn't work in the screen where there is devices list into the right there is the red circle, also about red LED.
It worked only the first time. Do you have some idea? Thank you so much
@Eric
Did you do what I suggested in my previous post?
@Eric, I already done but I didn't fix the problem.
I tried also soft reset but without results.
Now I've a new problem with MetaBase App. I disconnected by Metabase app the sensor and now if I try to reconnect the app close itself like a crash.
I installed the app in a laptop with windows10.
I don't know how to do
Thank you so much.. Tomorrow I'm trying to do a firmware update using iOS
@denisb,
Great, keep us updated.
It seems your metatracker is stuck in log mode but works fine if you can just update or reset it with an iPhone and a fresh MetaBase install.
I had this happen to someone else and the iOS firmware update fixed everything.
@Laura @Eric I fixed updating firmware by iPhone and now all it's ok.
Thank you so much for your time
@denisb,
Wonderful!