›

MetaMotion R broke

SamSam
in Hardware

Hello. I have discovered several MetaMotion R devices I haven't been using for some time have broken. They are not visible in MetaBase app. Some of them probably broke when I was updating firmware to 1.4.1 on them. There were cases when the device disconnected during firmware update and then failed to reconnect. I put them away for some time thinking they would come back to life later but apparently they haven't. What can I do to repair/reset/unbrick them?

Comments

  • EricEric

    Can you see the devices with the nRF Connect app?

  • SamSam

    @Eric said:
    Can you see the devices with the nRF Connect app?

    no

  • EricEric

    Are they simply out of power?

  • SamSam

    @Eric said:
    Are they simply out of power?

    I put them on charge for the whole night

  • EricEric

    Contact support (https://mbientlab.com/contact/) and link them to this thread. Unbricking your boards probably will require sending them to our office.

  • SamSam

    @Eric said:
    Contact support (https://mbientlab.com/contact/) and link them to this thread. Unbricking your boards probably will require sending them to our office.

    They suggested me to fill out RMA and said devices had to be under warranty. However, 30 days have passed since I purchased these devices. So there's nothing I can do?

  • EricEric
    edited August 2018

    Did you tell them the board bricked during the update to firmware v1.4.1?

    Fill our the RMA regardless, support needs all the information they need to verify the issue.

This discussion has been closed.